...
The Initial Value may be set to a specific number or state. This value is used when the controller starts from power up or the Schema is instructed to reset on download.
Browse Access describes the usage of each variable within an HMI.
Update to Flash specifies whether the variable value should be saved in FLASH. If the update is set for 'On Command' then the variable is written to FLASH when the Flash Write operator commands. If the update is set for 'On Command and Power Loss' then the variable is written to FLASH when either power is lost or commanded by the Flash Write operator.
Merge Behavior describes how the variable is to be treated when a schema is downloaded using the continue schemas (merge mode) option.
The Access Level column specifies whether the variable initial value can be change in Schema Viewer without a password (Operator Level) or if a password is required (Engineering Level).
Scope Note comments for the variable are displayed when hovering over that particular variable and in this table.
Labels for Boolean variables' values are displayed in the schema during simulations. These labels may be made more meaningful in the Low and High Label cells.