Software Release Notes - 4.5 Patch 2 (v4.5.264)
Introduction
These software release notes describe Release 4.5 Patch 2 of the Smart Valve Firmware. This patch includes enhancements and bug fixes. See below for details.
DOWNLOAD LINK
Smartvalve.4.5.264.$cc (4.77 MB)
Note: This file is included in the Design Pad and/or Schema Viewer v4.5.2xx installation. It can be found in \Program Files\Fairmount Automation\<PROGRAM NAME> folder (where <PROGRAM NAME> is 'Design Pad G4' or 'Schema Viewer G4').
Release Date
April 24, 2012
Download Contents
This file contains the firmware v4.5.264 for the Smart Valve Actuator.
File
...
Signatures
File Name | File Size | File Date/Time |
---|---|---|
Smartvalve.4.5.264.$cc | 4,884 MB | 04/24/2012 4:01PM |
INSTALLATION
Special Considerations
- Power should not be removed during the firmware update process or the device may need to be returned to the factory.
- As always, customers should ensure the updated software meets their requirements in a test environment prior to deploying in a production environment.
Due to the time needed to perform an IR update, it is recommended that the firmware update be done whenever possible using the Ethernet interface (a few minutes) rather than the serial IR interface (40+ minutes).
Updating Smart Valves using Ethernet:
- Ensure the Smart Valve(s) are configured (IP address loaded, etc.) to be on the same network as the computer that is performing the update.
- Start Design Pad or Schema Viewer v4.5.264 or higher.
- Select 'Use Ethernet' from the Communications Menu.
To Update a Single Smart Valves:
a. Open the Workspace and HWI associated with the Smart Valve to update.
b. Choose 'Firmware Update' from the Communications Menu
c. Press the 'Browse' button and select the Smartvalve.4.5.264.$cc file
d. Keep 'Preserve network settings after reboot' checked.
e. Press the Upload button to start the update process.
To Update Multiple Smart Valves:
a. Open the Workspace associated with the Smart Valves to update.
b. Right-click on the word 'Workspace' in the Workspace window and select Update Firmware (All Ethernet Hardware) from the Communications sub-menu.
c. Press the 'Browse' button and select the Smartvalve.4.5.264.$cc file
d. Select the Smart Valves to update in the 'Select Ethernet Hardware' window.
e. Keep 'Preserve network settings after reboot' checked.
f. Press the 'Upload' button to start the update process.
During the firmware update process, any existing Smart Valve program will be erased. If desired, reprogram valve by opening the desired program and selecting Program Hardware (reset schemas) from the Communications Menu.
Updating the Smart Valves using IR:
- Start Design Pad or Schema Viewer
- Open the Workspace and HWI associated with the Smart Valve to update.
- Choose 'Firmware Update' from the Communications Menu
- Remove the IR blocking plug (if installed) and align the IR wand to the actuator
- Select the Smartvalve.4.5.264.$cc file when requested
- Follow the on-screen instructions to complete the download
During the firmware update process, any existing Smart Valve program will be erased. If desired, reprogram valve by opening the desired program and selecting Program Hardware (reset schemas) from the Communications Menu.
ENHANCEMENTS AND CHANGES
Enhancements
- Enhanced the Ethernet port handling in the software which improved some reconnect issues on systems where multiple protocols were used. (SWCHA-610)
Changes
- In cases where the Snapshot Data Recorder operator was used in the program, and the trigger pin was removed, a crash in the device may occur when the schema is executed. This has been resolved and the device will no longer crash. (SWCHA-634)
...