Page Comparison

{scroll-pagetitle}Digital Outputs{scroll-pagetitle}
h1. Digital Outputs

Each FAC-2100 has two opto-isolated digital outputs that can operate in a Basic On/Off mode or Waveform Mode.


h1. Basic On/Off Mode
In Basic On/Off Mode the digital output is controlled to a static activate on state or to a static deactivated off state.


h1. Waveform Mode (Variable Frequency and Duty Cycle)
Waveform Mode transforms the channel into a variable frequency and duty cycle waveform generator.

h1. Wiring
{scroll-align-center}!Installation - Digital Out.png!
{*}Suggested Digital Output Wiring{*}{scroll-align-center}

\\
The suggested wiring above uses digital output 1 that can be used for Basic On/Off or Waveform Mode. Digital output 2 could be wired in a similar configuration.  Also, since the output is isolated, the load can be driven in a source or sink configuration.  For example, in the above diagram place a jumper from pins A to b, Load+ to pin B, and Load- to pin c. 


\\
{page-break}
{scroll-ignore}
[!FA_Inclusion_Library^FAprev.png!|PDG:Digital Inputs (FAC2100)] [!FA_Inclusion_Library^FAnext.png|PDG:align=right!|Relay Outputs (FAC2100)]
{scroll-ignore}